Sulphamethoxazole in Co-trimoxazole

Sulphamethoxazole in Co-trimoxazole

Sample Type: Serum

Test name: Sulphamethoxazole in Co-trimoxazole

Condition / Indication: Requesters have found these assays to be of value in patients with renal failure and/or high-dose co-trimoxazole therapy. Also in monitoring absorption in neutropenic patients.

Advance Warning: Not normally required during our core working hours (Mon – Fri 09:00 – 17:15). Please contact laboratory to discuss the possibility of this assay being performed on Saturdays, Sundays and Bank Holidays.

Sample Required: Approx. 1-2mL of separated serum (the minimum acceptable is 100µL). Samples may be sent by post. Transport time must be <5 days. Samples should be kept at 4°c if there is a delay in sending. Please contact laboratory if in doubt as sample integrity may be affected. Samples must be sealed and packed to conform to current regulations. Leaking samples may not be processed.

Timing of Samples: We recommend a pre dose sample and a post dose ample, taken either 1 hour after the end of iv administration or 2 hours after oral administration.

Test Information Required:

• Patient name, sex and age
• Laboratory number
• Dosage, frequency and timing of samples
• Clinical Summary
• Other medications (essential)
• Address for report
• Phone (fax if preferred) number for report or email address for an electronic copy
• Contact name
• Appropriate hazard warnings

Results: Results will be telephoned/faxed or emailed on the day of receipt for samples received between 9am and 3pm Monday to Friday. A written confirmation report will be sent by post.

Reference Range: Pre dose < 100 mg/L Post dose 120-150 mg/L but <200 mg/L

Container: Serum (Gold top)

Referred outside NBT for analysis? No

Discipline: Assay

Turnaround Time: <3 days

Microsoft Office document icon ARL Request Form.doc

Re-assay Interval: 6-8 Days – Assuming initial results are within expected range.